Loading...
« previous topic   next topic »
Pages: 1 [2]   Go Down
Author Topic: Need Guidance on Pausing and Resuming 4 Digit 7 Segment LED Countdown Clock  (Read 864 times)
0 Members and 1 Guest are viewing this topic.
SteveOr
Offline Offline
Newbie
*
Karma: 0
Posts: 29
View Profile
« Reply #15 on: December 05, 2012, 11:50:25 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Quote from: CrossRoads on December 05, 2012, 07:35:40 pm

Code:
...
  if ((time_running == 1) || (time_running == 2))  // fencing time is counting down or delay time is counting down
  {
    ...

Is this where your button press is a factor?  If so, how do you make your sketch send these values?
Logged

CrossRoads
Global Moderator
Boston area, metrowest
Offline Offline
Brattain Member
*****
Karma: 249
Posts: 16572
Available for Design & Build services
View Profile
WWW
« Reply #16 on: December 06, 2012, 12:39:52 am »
 Bigger Bigger Smaller Smaller Reset Reset
No, there is another area for keypresses. Once a keypress happens, that part turns these flags off if they were on.  This section then gets passed over until something happens to turn one of these on again.
Logged
Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17

SteveOr
Offline Offline
Newbie
*
Karma: 0
Posts: 29
View Profile
« Reply #17 on: December 11, 2012, 06:04:12 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Then how does the "if ((time_running == 1) || (time_running == 2))" work in your sketch?
Logged

Pages: 1 [2]   Go Up
Print
« previous topic   next topic »
 
Jump to: