Pages: [1]   Go Down
Author Topic: ADXL193: ST pin?  (Read 491 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
Karma: 0
Posts: 56
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I can't figure out from datasheet how I should connect ST pin?
I need no self-test, just for regular reading from OUT pin?
Should I ground ST or just leave it hanging?

United Kingdom
Offline Offline
Tesla Member
Karma: 227
Posts: 6639
Hofstadter's Law: It always takes longer than you expect, even when you take into account Hofstadter's Law.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

You can do either - the ST pin has an internal pulldown resistor to ground. Ground it if you think it is picking up interference.

Formal verification of safety-critical software, software development, and electronic design and prototyping. See Please do not ask for unpaid help via PM, use the forum.

Pages: [1]   Go Up
Jump to: