Pages: [1]   Go Down
Author Topic: microSD using Atmega8 and Arduino IDE  (Read 1398 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
Karma: 0
Posts: 53
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Has any of you connected a microSD card to an Atmega8, using just the Arduino IDE? Is it difficult or you just have to follow the Arduino tutorial, in the examples section?

Thank you!

Global Moderator
Boston area, metrowest
Online Online
Brattain Member
Karma: 548
Posts: 27372
Author of "Arduino for Teens". Available for Design & Build services. Now with Unlimited Eagle board sizes!
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Atmega8 supports SPI? Then I would think it could interface to uSD card if the mega8 has enough SRAM to support the fat16lib SD library.
You will need 3.3V power & logic level translation to avoid damaging the SD/uSD card.

Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at
Arduino for Teens available at

Pages: [1]   Go Up
Jump to: