Go Down

Topic: Problem with communication between Arduino and ScadaBR (Read 324 times) previous topic - next topic

newrcv

Problem with communication between Arduino and ScadaBR
I'll try to describe the operation of the engines on the bridge h .... I'm using a shield that fits in arduino which uses the following digital outputs:
variable;
Sobe> SUB - 10 +8 pin M2 and M3 Pin 11 +13
Falls> DES - M2 and M3 pin 10 +7 11 +12 pin
Front> FRE - M1 and M4 9 +4 pin pin 5 +16
The Doggy> TRA - M1 and M4 pin 9 +3 +15 pin 5
Left> ESQ - M1 and M4 pin 9 +3 +16 pin 5
Right> DIR - M1 and M4 9 +4 pin pin 5 +15
LEDs> LIGHT - 6 pin
The idea is to use the variables within the arduino when scadabr send it sends a command to the variable that controls the 4 digital outputs of the above combinations.

This file is used when i can control the set of outputs but are controlled individually and i need to be managed as i asked earlier.

Thanks for your support!


Hugs!

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy