Go Down

Topic: I2C voltage problem (Read 2180 times) previous topic - next topic

mystical



This is not the problem here, problematic are the pull-ups on board of your device. For an I2C bus pull-ups should be installed only once per bus and not on every device PCB. I would try to remove the pull-ups on the PCB of your amanero device.

That is a really good idea. The resistors are smd's so I need to muster up some courage to have a go at that. Thank you for taking the time to understand the issues and providing very constructive help.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy