Go Down

Topic: Stepper motors from Wishblade cutter (Read 608 times) previous topic - next topic


I took stepper motors from a Wishblade cutter. Info on motors:


I have Seeed Studio Motor Shield: http://www.seeedstudio.com/depot/motor-shield-p-913.html?cPath=132_134

I have Pololu Motor Controller: http://www.pololu.com/catalog/product/1372

Is it possible to connect the stepper motors to the motor controllers?


I got the stepper motors working at 12V using the Seeed Studio Motor Shield. I found out that the Pololu Motor Controller doesn't support stepper motors. Any suggestions for motor controllers for 3 or 4 stepper motors?

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131