Pages: [1]   Go Down
Author Topic: Problem with communication between Arduino and ScadaBR  (Read 236 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Problem with communication between Arduino and ScadaBR
I'll try to describe the operation of the engines on the bridge h .... I'm using a shield that fits in arduino which uses the following digital outputs:
variable;
Sobe> SUB - 10 +8 pin M2 and M3 Pin 11 +13
Falls> DES - M2 and M3 pin 10 +7 11 +12 pin
Front> FRE - M1 and M4 9 +4 pin pin 5 +16
The Doggy> TRA - M1 and M4 pin 9 +3 +15 pin 5
Left> ESQ - M1 and M4 pin 9 +3 +16 pin 5
Right> DIR - M1 and M4 9 +4 pin pin 5 +15
LEDs> LIGHT - 6 pin
The idea is to use the variables within the arduino when scadabr send it sends a command to the variable that controls the 4 digital outputs of the above combinations.

This file is used when i can control the set of outputs but are controlled individually and i need to be managed as i asked earlier.

Thanks for your support!


Hugs!

* modbus_proteus.ino (23.86 KB - downloaded 2 times.)
Logged

Pages: [1]   Go Up
Jump to: