Pages: [1]   Go Down
Author Topic: Stepper motors from Wishblade cutter  (Read 380 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Full Member
***
Karma: 3
Posts: 221
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I took stepper motors from a Wishblade cutter. Info on motors:

http://www.eminebea.com/en/product/rotary/steppingmotor/pm/standard/pm42s-096.shtml

I have Seeed Studio Motor Shield: http://www.seeedstudio.com/depot/motor-shield-p-913.html?cPath=132_134

I have Pololu Motor Controller: http://www.pololu.com/catalog/product/1372

Is it possible to connect the stepper motors to the motor controllers?
Logged

Offline Offline
Full Member
***
Karma: 3
Posts: 221
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I got the stepper motors working at 12V using the Seeed Studio Motor Shield. I found out that the Pololu Motor Controller doesn't support stepper motors. Any suggestions for motor controllers for 3 or 4 stepper motors?
Logged

Pages: [1]   Go Up
Jump to: