Pages: [1]   Go Down
Author Topic: help, stepper with l298n  (Read 489 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

hi, i'm new in the world of stepper motor and this is my first time i try to drive one of these motor. i have a nmb stepper motor (http://www.motors.wrobots.com/PM35L-048-HPD4.php) 5 wire(unipolar i think). anyway i tried the typical connection with 8 diodes at the output of l298n, so at the start it work good but after some seconds (30 sec more or less) the IC l298n become very warm and the motor doesn't work anymore

can someone help me?

sorry for my english
Logged

Malaysia
Offline Offline
Sr. Member
****
Karma: 7
Posts: 393
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

hi there michefrio,
Anyway could you post a picture and give a more detail description about your problem?
is the 298 warm or hot? btw what type of diode did you use? when you say motor no work no more what does that mean?
Logged

Pages: [1]   Go Up
Jump to: