That means if the Current Source Register is once set, it can only be reset by making a reset by pulling RSTN to low? And it can't be reset by the 'init bit'?
of course I already have a code for one matrix,
mounted yeah, going no. the code isn't working.
If you do a software reset and set the shdn-bit to 0, are all controll registers resetted then (set to defaultvalues) ? because thats not written in the datasheet.
And i'm not talking anymore about the shdn-bit but about the init-bit.
And I have a second code for two matrix, where I just wanna understand the logic
the CS is 0x00, so the leds won't light!
Both codes are yours which you posted here.
My hardware is working for sure, I measured each pass.