Pages: [1]   Go Down
Author Topic: microSD using Atmega8 and Arduino IDE  (Read 1365 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
**
Karma: 0
Posts: 53
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Has any of you connected a microSD card to an Atmega8, using just the Arduino IDE? Is it difficult or you just have to follow the Arduino tutorial, in the examples section?

Thank you!
Logged

Global Moderator
Boston area, metrowest
Offline Offline
Brattain Member
*****
Karma: 524
Posts: 26438
Author of "Arduino for Teens". Available for Design & Build services. Now with Unlimited Eagle board sizes!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Atmega8 supports SPI? Then I would think it could interface to uSD card if the mega8 has enough SRAM to support the fat16lib SD library.
You will need 3.3V power & logic level translation to avoid damaging the SD/uSD card.
Logged

Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

Pages: [1]   Go Up
Jump to: