I want to see if it is possible to use an atmega32u4 as a keyboard interface for some CNC mills to jog the mill etc.
The mills are controlled by a PC through parallel or usb depending on the model. The keyboard needs to work through USB.The teensy looks nice pretty much what I was after but I want to make it my self though. That will allow me to hook a few other features on to the same board i.e. the emergency stop button which goes into the motor controller board.
I suggest you download the Leonardo schematic from the main site and base your design on that, leaving off the bits you don't need e.g. either the USB power feed-through transistor or the voltage regulator (depending on how you intend to power it) and the LEDs.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16