Pages: [1]   Go Down
Author Topic: INSTRUCTIONS to skip verification  (Read 646 times)
0 Members and 1 Guest are viewing this topic.
Brasil
Offline Offline
Full Member
***
Karma: 4
Posts: 125
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,
I was getting furious, because my sketch already had 140kb, and was taking about 1 minute to upload.

Then, I figure out how to "skip" verification (The second "stage" of upload).

To disable verification, go to:
ArduinoSoftwareFolder/hardware/arduino/sam/plataform.txt

Then, open it and go to the last line (It's what "calls" bossac to upload the sketch). Find the following section:
"-e -w -v -b"
and alter it to:
"-e -w -b" (just remove the "-v", witch means: VERIFY code after upload).

After all, it should be like this:
tools.bossac.upload.pattern="{path}/{cmd}" {upload.verbose} --port={serial.port.file} -U {upload.native_usb} -e -w -b "{build.path}/{build.project_name}.bin" -R

Save the file, close and open Arduino IDE. Select another plataform and select Arduino Due Programming port just to make shure.

Have fun.
« Last Edit: May 12, 2013, 12:51:09 am by ivanseidel » Logged


Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Thank you!
Logged

Pages: [1]   Go Up
Jump to: