Go Down

Topic: Code Check for ROV (Read 1 time) previous topic - next topic

Graynomad

You need a receiver and transmitter at each end, but these come in a single chip so that's one chip at each end. Same as RS-232 in that regard but 2x the number of wires required.

Quote
would this require 4 MAXRS485 convertors?

Yes, but you wouldn't use that chip, there are plenty around that are for full duplex, eg LT1791, ISL31483 or my favourite the LTC490, duplex in an 8-pin pack.

______
Rob

Rob Gray aka the GRAYnomad www.robgray.com

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy