Pages: [1]   Go Down
Author Topic: Home etched Severinos  (Read 462 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 1
Posts: 4
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

1st post so I'm not sure if this is quite the right place to post, but here goes.

I etched a couple of single sided Arduino boards using toner transfer. Boy was that a lot of holes to drill. I had DIP atmega328P's to use up so that was OK, but next time around a surface mount design would be nice. Perhaps there is already a good one out there.



Link: http://smokedprojects.blogspot.com/2012/12/home-made-arduinos.html
Logged

Pages: [1]   Go Up
Jump to: