Pages: [1]   Go Down
Author Topic: How would you go about burning a bootloader to atmega 2560?  (Read 290 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 48
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have a blank atmega 2560 chip that has no boot loader. How would burn a boot loader to it?
Logged

Global Moderator
Offline Offline
Brattain Member
*****
Karma: 452
Posts: 18694
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

See this page:

http://www.gammon.com.au/forum/?id=11635

I burn a bootloader onto a Mega2560 board there. If you have the chip (not on that exact board) you just need to work out the pinouts. Basically you need MOSI, MISO, SCK, RESET, +5V and GND connected as described there.
Logged

SF Bay Area (USA)
Offline Offline
Tesla Member
***
Karma: 106
Posts: 6378
Strongly opinionated, but not official!
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The 2560 is "unique" in that it's bootloader lives beyond the 64kword limit of several programmer protocols (like stk500v1 used by ArdunioISP.)  Several popular inexpensive AVR programmers are known to have problems.  Since Nick's solution is designed from the ground up to be able to program the 2560, I can't think of a better solution.
Logged

Pages: [1]   Go Up
Jump to: