Go Down

Topic: can't use arduino as isp (Read 1 time) previous topic - next topic


Hi all!

I've run into a really weird problem recently:

Normally, I use my arduino uno r3 as an isp to program my other AVR chips (usually an attiny84) but for some reason, I can't program an atmega168 or an atmega328!

I keep getting an invalid device signature (usually either all 0s or all Fs, but sometimes a combination). My connections are fine, I checked them a hundred times, and when I rewire it to the attiny84, everything's alright. It just won't work with the 168 or 328 though. I've even tried 2 different 328 chips. Does anybody know what could be happening here?



Assuming the chips are new, have you burnt a bootloader first to set the fuses.
Don't PM me for help as I will ignore it.


I've messed around with the fuses on the 168, but the 328s have the bootloader burnt. Nothing changes when I add a 16MHz crystal though...


Apart from suggesting following this http://arduino.cc/en/Tutorial/ArduinoISP and remembering to put a capacitor across reset & ground on your UNO after uploading ArduinoISP sketch and then copy/pasting error messages into your next message.
Don't PM me for help as I will ignore it.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131