Go Down

Topic: Home etched Severinos (Read 939 times) previous topic - next topic


1st post so I'm not sure if this is quite the right place to post, but here goes.

I etched a couple of single sided Arduino boards using toner transfer. Boy was that a lot of holes to drill. I had DIP atmega328P's to use up so that was OK, but next time around a surface mount design would be nice. Perhaps there is already a good one out there.

Link: http://smokedprojects.blogspot.com/2012/12/home-made-arduinos.html

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131