Pages: [1]   Go Down
Author Topic: connection problem between the wire and the circuit  (Read 291 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 1
Posts: 8
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I'm doing the circuit in the attached picture and I do not understand the connection between the wire and the circuit for the sensor tmp36 a 3 pin (gnd pin, pin analog pine v +) and there are only 2 wires used in the shielded wire and there are 3 (2 inner wire and a wire multibrain outside). can you explain how the physical connection between the two?

thank you in advance for ideas!

* tmp36.jpg (34.39 KB, 403x344 - viewed 21 times.)

Pages: [1]   Go Up
Jump to: