I want to enable selecting between two different modes in my project. Basically one is a long period and the other is shorter. I want to use a simple spst switch on a digital pin with the internal pullup resistors. This works well because it will keep the correct mode even if reset.I have a slight concern about leaving the switch on all the time. Is that a potential problem? I think it's probably a non-issue but I'm experienced enough to know that assuming things is less reliable than checking with people who know better.It's a non-issue, just microamps flow if the switch is closed with the internal pull-up enabled, and no current flow if the switch is open.Lefty
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16