Go Down

Topic: Receive ir signal with attiny13  (Read 258 times) previous topic - next topic

Arduino14

I, after had seen that is possible use a 433mhz transmitter with this little avr, I would to use it in order to receive ir signal from a remote and then, for example, light a led. Googling a bit I've seen many Russian people that have done this but in assembler. I'd like to compile it using the arduino ide. Does someone tried this?


Arduino14

You're wrong, this is for use the receiver with arduino, not attiny! 

mrburnette

... I would to use it in order to receive ir signal from a remote and then, for example, light a led. ...
Does someone tried this?
It is very easy on a tiny85, I have not worked with the tiny13.
IR on a Tiny85

Ray

Arduino14

#4
Jun 04, 2016, 03:06 pm Last Edit: Jun 04, 2016, 03:07 pm by Arduino14
The code is incompatible with the tiny13 because different frequency

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy