Go Down

Topic: Multi Copter IO Shield v2 for the Arduino Due (Read 859 times) previous topic - next topic


Hello all,
  I have produced the second version of my multi copter IO shield for the Arduino Due.  This one features 16x 5v IO for interacting with the receiver, ESC, and servos.  This IO is automatically bidirectional, so no special configuration is needed to use the associated pins in either capacity (standard Arduino configuration is still required).  Of these 5v IO, 14x of them are located in a three pin right angle header for easy connection of the receiver, ESC and motors.  This shield does not include sensors, but provide very easy access to the communication buses on the Due by grouping the bus pins with both ground and 3.3v power.  For more information, read my blog post.
Please let me know if you have any questions.  Thanks,

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131