Pages: [1]   Go Down
Author Topic: Correct pitch of ATMega128 TQFP64  (Read 402 times)
0 Members and 1 Guest are viewing this topic.
Brazil
Offline Offline
Newbie
*
Karma: 0
Posts: 16
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am planning to buy some ATmega128 (TQFP64) and some DIP adapter (http://www.elecfreaks.com/store/qfp324464-to-dip-adapter-08mm-pitch-p-245.html).

My problem is to discover the correct pitch I need to look for. 0.8mm or 0.5mm.

I believe that ATMega128 is 0.8mm. Am I right ?
Logged

United Kingdom
Offline Offline
Tesla Member
***
Karma: 220
Posts: 6587
Hofstadter's Law: It always takes longer than you expect, even when you take into account Hofstadter's Law.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

See the Packaging Information section in http://www.atmel.com/Images/doc2467.pdf.
Logged

Formal verification of safety-critical software, software development, and electronic design and prototyping. See http://www.eschertech.com. Please do not ask for unpaid help via PM, use the forum.

Norfolk UK
Offline Offline
Edison Member
*
Karma: 52
Posts: 2214
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

According to the data sheet 0.8

* doc2467x.pdf (95.47 KB - downloaded 15 times.)
Logged

Handle every stressful situation like a dog. If you can't eat it or hump it. Piss on it and walk away.

Brazil
Offline Offline
Newbie
*
Karma: 0
Posts: 16
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thank you  !

Some day I will know how to read the entire datasheet smiley

Now I understand that there are two packages: 64A (0.8mm) and 64M1 (0.5mm). But only the 64A is TQFP.

Thanks again !!!

Logged

Pages: [1]   Go Up
Jump to: