Go Down

Topic: liquid sky laserjet M56750fp brushless driver help needed (Read 998 times) previous topic - next topic

innazone

Hello

I'd like to use the polygon stepper mirror from a laserjet printer for a simple laser projector for liquid sky effects. The stepper driver is an M56750 fp with 4 inputs, lead 1 V+ 2 pin 5 accel 3 pin 6 decel and 4 ground,

the driver pdf is here http://www.datasheetcatalog.org/datasheet2/a/0a92y8fji8ri01xlwcxr5w1ug7py.pdf.

I don't have a clue how to possibly program an arduino to make it go though, any help would be much appreciated

BW

Nick

Zapro

If you are going to use it like a liquid sky effect, you must keep in mind that you lose a lot of the light this way, unless you want it to be just as wide as the deflection on a whole turn of the mirror face.

Try connecting up power and ground the Accel. pin, then it should run at maximum speed.

// Per.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy