Go Down

Topic: ROB-10847 DC Stepper Motor with EasyDriver Shield (Read 2049 times) previous topic - next topic


I want to use the following stepper motor: http://www.sparkfun.com/products/10847
and the following shield: http://www.sparkfun.com/products/10267

I would like to use a 12V power supply as well.

A simple tutorial, http://bildr.org/2011/06/easydriver/

How would I hook up my stepper motor??



I see that the motor wants 3V at a max of 2 amps but the Shield doesn't want a voltage that low to drive it. Is there a different shield that I could use.


If you are using the 125oz/in stepper from Sparkfun, the wiring shown in the OP's image is not correct. I learned this the hard way and fried my bigeasydriver board.

The correct wiring is:

Black: A hot
Green: A neutral

Red: B hot
Blue: B neutral

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131