next topic »

[on:]

Hello folks,

I have problems to connect to the EasyVR Shield Board through the pc (https://www.sparkfun.com/products/10963) when using the "UP-Flash update mode".

The PC mode works fine but I need the UP mode too...

After setting the jumper for the UP mode and connecting with the ubs/rs232 adapter the red led is shinning while the green led keeps dark.
Now I started the VR Commander and presses the "Connect" button. I get the following message "Could not detect device connected to port "COM4" "

I've checked already the /XM Pin, about 2,8V thats ok according to the vr manual.

Only the  tx-led of the usb/rs232 adapter is flashing after pressing the "Connect" Button in the VR Commander.
The dark rx-led signalizes me that the usb/rs232 adapter is getting no response from the easyvr shield board.

Can someone help me out?

[Reply #1 on:]

I'm having similar issues.  Anyone ever respond?

[Reply #2 on:]

We need more info.  Like, why are you putting it in "UP" mode.  The manual says you don't need to "connect" with VR Commander.  That's your first mistake. 

What, specifically, are you trying to do?

The only reason why you should be putting the shield in "UP" mode (Update) is if your installing a new version of the firmware, or uploading new sound tables to the shield.