Go Down

Topic: Power loops(?) on a motor controller shield (Read 435 times) previous topic - next topic


I made a video to explain what's going on.  It's about 10 minutes, but is probably easier to digest than my trying to type all of that out.


I figure I'm probably not doing something right, or maybe worrying over something that's not a problem.  Any guidance would be appreciated.


The amazon seller has decided to send me a new board. He said it would be here Friday. We'll see how that turns out.

I was testing continuity on the board last night and I think there is some conductivity, but not enough to beep, between the ext power and the ground pins. Would that be enough to light up those LEDs?

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131