Pages: [1]   Go Down
Author Topic: Power loops(?) on a motor controller shield  (Read 222 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
**
Karma: 0
Posts: 82
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I made a video to explain what's going on.  It's about 10 minutes, but is probably easier to digest than my trying to type all of that out.

https://www.youtube.com/watch?v=mxsfCqXIuOM

I figure I'm probably not doing something right, or maybe worrying over something that's not a problem.  Any guidance would be appreciated.
Logged

Offline Offline
Jr. Member
**
Karma: 0
Posts: 82
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The amazon seller has decided to send me a new board. He said it would be here Friday. We'll see how that turns out.


I was testing continuity on the board last night and I think there is some conductivity, but not enough to beep, between the ext power and the ground pins. Would that be enough to light up those LEDs?
Logged

Pages: [1]   Go Up
Jump to: