Go Down

Topic: Due Minimal Circuit (Read 2836 times) previous topic - next topic

tsaG

Hi!

I want to etch my own Board with a due. What do I really need to get them to work? I want to flash the Chip with JTAG. So I dont need the Config 5V Circuit with the Tiny. What about the erase circuit? I planned to use a simple button to reset the Chip since I dont need a automatic circuit for this.

It would be more simple if I could use the USB Interface. As described in this clone, they left out the Tiny Chip.
http://www.ebay.de/itm/TAIJIUINO-Due-Pro-Board-completely-compatible-with-Arduino-Due-/130825173003?pt=LH_DefaultDomain_0&hash=item1e75c9b80b#ht_6491wt_1144


Im using this Circuit to build mine
http://arduino.cc/en/uploads/Main/arduino-Due-schematic.pdf

Is there a complete Pinmapping for the due available? Since the Diagramm on the arduino page is incomplete.

regards

Graynomad

Quote
Is there a complete Pinmapping for the due available?


http://arduino.cc/forum/index.php/topic,132130.0.html

______
Rob
Rob Gray aka the GRAYnomad www.robgray.com

tsaG

Hi, Thanks! But I was looking for a Pinmapping like the atmega has (for the Chip only).

Like this
http://arduino.cc/en/Hacking/PinMapping2560

Graynomad

I don't know of any drawings like that for the Due. Most of that information is in my diagram (chip pin numbers etc) but in a PCB-centric layout not laid out as seen on the chip.

______
Rob
Rob Gray aka the GRAYnomad www.robgray.com

neslekkim

no drawing of the chip, but the same table is here:

http://arduino.cc/en/Hacking/PinMappingSAM3X


tsaG


no drawing of the chip, but the same table is here:

http://arduino.cc/en/Hacking/PinMappingSAM3X




But the Chip has 144 Pins, or am I wrong?

Graynomad

Correct, and that table doesn't show the physical pins which I gather is what you want.

______
Rob
Rob Gray aka the GRAYnomad www.robgray.com

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy