Pages: 1 [2]   Go Down
Author Topic: Decoupling capacitors  (Read 1362 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Edison Member
*
Karma: 20
Posts: 2115
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

uh hmmm, no.

But i'll certainly try it sometime smiley
Logged

Global Moderator
Boston area, metrowest
Offline Offline
Brattain Member
*****
Karma: 443
Posts: 23837
Author of "Arduino for Teens". Available for Design & Build services. Now with Unlimited Eagle board sizes!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

@Jack, the 8.pF is for very high frequency noise on the line.

Logged

Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

United Kingdom
Offline Offline
Tesla Member
***
Karma: 220
Posts: 6587
Hofstadter's Law: It always takes longer than you expect, even when you take into account Hofstadter's Law.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

I think the 8.2pF must be a misprint. A capacitor of that value isn't going to do anything useful by way of decoupling, especially given the distance between the Vcc and ground pins of that device. My guess is that they meant 8.2uF tantalum electrolytic, and ceramic for the other capacitor (1uF).
Logged

Formal verification of safety-critical software, software development, and electronic design and prototyping. See http://www.eschertech.com. Please do not ask for unpaid help via PM, use the forum.

Pages: 1 [2]   Go Up
Jump to: