They always look ugly, with more than a couple of traces. However, you should look at the top and bottom trace layers separately to get a better idea of how the layoutwent. Also, the most obvious problem with auto-routing, the way you did it, is thatthe power and ground traces are not nice and fat [ie, 30-50 mils], like they should normally be to handle non-trivial currents.
At the top of the IC on the left side there's some really fine lines that look like nets that didn't get routed. It's a good start though!
So I should change the width to 50 mil and then click on each power and gnd trace? Is there a quick way to change them all at one time?
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16