They always look ugly, with more than a couple of traces. However, you should look at the top and bottom trace layers separately to get a better idea of how the layoutwent. Also, the most obvious problem with auto-routing, the way you did it, is thatthe power and ground traces are not nice and fat [ie, 30-50 mils], like they should normally be to handle non-trivial currents.
At the top of the IC on the left side there's some really fine lines that look like nets that didn't get routed. It's a good start though!
So I should change the width to 50 mil and then click on each power and gnd trace? Is there a quick way to change them all at one time?