Go Down

Topic: help needed datasheet included (Read 1 time) previous topic - next topic


hello im looking to see if this lcd+touch would be off some use for my arduino

it comes from a wince gps device (keomo) which i dont need anymore

thanks in advance

datasheet from the lcd below


Theoretically, you could drive it from an Arduino. However, it has more than 30 inputs, so you would need a lot of Arduino pins or I/O expanders, shift registers etc. Also it is a 3.3V device, so you would need to use a 3.3V Arduino or else level-shift the signals. More trouble than it's worth IMHO.
Formal verification of safety-critical software, software development, and electronic design and prototyping. See http://www.eschertech.com. Please do not ask for unpaid help via PM, use the forum.


thank you for the reply

ok this device has to go into the box for a later project then
im just starting with mcu's so im nowhere near that sort of things yet
again thank you for your time


Go Up