Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: help needed datasheet included  (Read 137 times)
0 Members and 1 Guest are viewing this topic.
jhax78
Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
« on: December 30, 2012, 01:08:38 am »
 Bigger Bigger Smaller Smaller Reset Reset
hello im looking to see if this lcd+touch would be off some use for my arduino

it comes from a wince gps device (keomo) which i dont need anymore

thanks in advance

datasheet from the lcd below
http://www.datasheet4u.net/download.php?id=707666
Logged

dc42
United Kingdom
Offline Offline
Faraday Member
**
Karma: 131
Posts: 4673
View Profile
WWW
« Reply #1 on: December 30, 2012, 05:31:32 am »
 Bigger Bigger Smaller Smaller Reset Reset
Theoretically, you could drive it from an Arduino. However, it has more than 30 inputs, so you would need a lot of Arduino pins or I/O expanders, shift registers etc. Also it is a 3.3V device, so you would need to use a 3.3V Arduino or else level-shift the signals. More trouble than it's worth IMHO.
Logged
Formal verification of safety-critical software, software development, and electronic design and prototyping. http://www.eschertech.com

jhax78
Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
« Reply #2 on: December 30, 2012, 01:41:42 pm »
 Bigger Bigger Smaller Smaller Reset Reset
thank you for the reply

ok this device has to go into the box for a later project then
im just starting with mcu's so im nowhere near that sort of things yet
again thank you for your time

//jhax78
Logged

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: