Pages: [1]   Go Down
Author Topic: Arduino ADK R3 CTS Pin  (Read 305 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello,

I am investigating attaching an ANT Wireless Module to a Arduino ADK R3.

The ANT Interface Guide discusses two methods of interfacing; Synchronous Serial Interface and Asynchronous Serial Interface.

The Asynchronous Serial Interface requires that the Microcontroller was a CTS, TX and RX Pins.

Where is the CTS Pin on an Arduino ADK R3 Board?

Does one exist?

Thanks
« Last Edit: December 30, 2012, 06:22:53 pm by mcassell » Logged

Pages: [1]   Go Up
Jump to: