Go Down

Topic: [Solved]Hard Disk motor control... (Read 1 time) previous topic - next topic


Dec 30, 2012, 07:17 pm Last Edit: Dec 31, 2012, 08:51 am by coyotte Reason: 1
Hi all,
I've dismantled an old hard disk and I would like to have it spinning  without the electronic cards that was given with.

I've read here and there that this can be achieved using an ESC controller for RC brushless motors.
My problem is that the motor has 4 connections pins and the controller 3....
On the net I've found informations regarding the connection option and one speak about 3 coils pins and one common/ground.

Let's name the connections A, B, C and D.

Using my multimeter, I found the following values :
Between A and B I've found 5.8 Ohms. The same between B and C.
But I've found 3 Ohms between A & D, B & D and C & D.

Am I right if I say that the 3 coils connections are A, B & C, in a star scheme with D as a center point ?
(But should I not find 6 Ohms in place of 5.8 Ohms in that case ?)

Any information will be welcome.

By the way, I wish you a pleasant year 2013 full of health, love ...and arduino projects !

Best wishes,


PS: Please excuse my poor English level...

Conference over procrastination has been postponed to tomorrow


Looks to me like you can just ignore D and connect the ESC to A, B, and C.
Send Bitcoin tips to: 1G2qoGwMRXx8az71DVP1E81jShxtbSh5Hp


Thanks John... I'll try this option.

Happy New Year,


Conference over procrastination has been postponed to tomorrow


Hi John,
Just to let you know that it works perfectly !
Thanks a lot and best wishes for 2013 !!!

Conference over procrastination has been postponed to tomorrow

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131