Pages: [1]   Go Down
Author Topic: "Servo" library not working on other pin  (Read 346 times)
0 Members and 1 Guest are viewing this topic.
The Big Smoke
Offline Offline
Sr. Member
****
Karma: 0
Posts: 260
Hacking and Slashing
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Hey guys,

I'm trying to setup a Romeo board with a couple of servers in a pan and tilt combination. For some reason I cannot get the servos to move on any other ports than 9 & 10.

Normally this wouldn't be a problem but the onboard motor controller uses pins 6-9.

I've tried a couple of other libraries and the only one which worked was the legacy version by Todd Bot. (It basically delayed for anywhere between 700-2320us)

Does anyone have any thoughts?

[edit]

Totally in the wrong forum
« Last Edit: September 04, 2009, 05:43:17 pm by TeamMCS » Logged

The Big Smoke
Offline Offline
Sr. Member
****
Karma: 0
Posts: 260
Hacking and Slashing
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Ah. I think my build folder screwed up. After some messing around the stock MegaServo library worked great.

Time to get the robot movin'
Logged

London
Offline Offline
Faraday Member
**
Karma: 8
Posts: 6240
Have fun!
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The servo library that comes with Arduino 0017 has the MegaServo code so will work on any pin.
Logged

Pages: [1]   Go Up
Jump to: