Go Down

Topic: Servo chatter ? (Read 464 times) previous topic - next topic

KB3LNN

OK so I have a pan and tilt using two sg90 servos and have the code to run it using a joystick. Everything is fine I had got ten of these servos and found that not all but a few seem to chatter. My question is how to stop the  >:( ? Is their a misalignment in the servos that I can adjust? And will this condition if left on line for long period of time damage the servos? Thank you for your time.

Robert KB3LNN

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy