Is it possible I fried some pins on Duino instead? :/
Yes, that is possible if you were experimenting with the SPI lines. How was the LED connected? Did it have the appropriate current limiting resistors? If not, it may have fried the line drivers.
Well, I built myself an avr developing board. And it has resistors... They might be kinda small, but it has always worked until I connected the led to the SPI lines. :/ it's an rgb led and I wanted it to be bright, so I hooked up the smallest resistor according to some... led resistor calculating thingy. But, well it's some 70 ohms once and 100 ohms twice, but it failed when I connected Duino to it, yet the pins on Arduino are okay. I mean, at only point of time where more than 1 color was on, it was being programmed, sourcing energy from Arduino, pins of which are okay. I am confused. ;(
Edit: the Arduino is okay... But... how could I have fried the atmega32? I don't get it ;(