Go Down

Topic: IV-18 clock (Read 1 time) previous topic - next topic

olof_n

Hi!

After seeing Adafruits Ice Tube Clock I wanted to make my own clock based on a IV-18 tube.

The clock has the following features:
Clock mode
Alarm at specific time.
Timer mode (count down - alarm when zero)
Night light (3 LEDS PWM adjustable with trimpot)
The clock will automaticly fade out the VFD tube after some time. To light it up you put your hand above the clock (IR-LED + Photodiode).



I used the followning components:

ATMEGA328
IV-18 tube
MAX6921AWI driver IC
34063API  switching regulator. Stepped up 5V to 27V.

27V multiplexed workes fine. Other clocks on internet use much higher voltage (>50V) but that seems unnecessary and will  affect the tubes lifetime negative.

DS1307 clock IC.

The nice steel enclosure was made by my brother.





/Olof

pYro_65

Nice, those displays look nice with the internals visible. Good job.

robot797

could we please get the software you use?

tronixstuff


could we please get the software you use?


most likely based around the adafruit code.
https://github.com/adafruit/Ice-Tube-Clock/blob/master/firmware/iv.c
Check out my Arduino tutorials at http://tronixstuff.com/tutorials - Order my  Arduino book from http://nostarch.com/arduino

olof_n

Hi!

The code is not based on Adafruits code.
See http://forum.arduino.cc/index.php?topic=132993.msg1354582#msg1354582

The complete code is quite long but I have posted the important part.

Go Up