Go Down

Topic: Automated Reptile Control System(webserver, Data Logging, RTC and much more) (Read 39 times) previous topic - next topic

wallaceb


Hello, really nice project!
Can you explain how can you positioning the values into the tables of your html pages?
Do you need to refresh the page everytime you want see if there was a change in the reads, or the page is always "connected" to arduino?

THANKS!!


currently the code is written so you need to refresh the page any time you want to see what the current readings are. it would be very easy to add the HTML "refresh" tag to the code to get it to auto refresh.

i have finished my enclosure and posted some images below:










wallaceb

i attached my code and the different libraries i used

some things are not done, and i know if a few bugs that need to be fixed, but i would say 98% of everything is working fine.

note: written in IDE version 1.0

robtillaart

Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)

gvaf

Hi everyone
"wallaceb" you have done a very good job here.

Question: It possible this code to work on UNO ?

Thanks

wallaceb


Hi everyone
"wallaceb" you have done a very good job here.

Question: It possible this code to work on UNO ?

Thanks



unfortunately no. the entire sketch currently uses 106,000 bytes of FLASH, too much for the UNO. However with that said, most of the 106,000 bytes is the PROGMEM storage of the HTML pages. If the sketch was somehow changed to pull the HTML off the SD card instead, it might fit, but i have not checked.

Go Up