Go Down

Topic: General U8glib Question (Read 627 times) previous topic - next topic

Hello,

I'm trying to create a system with a bit of pizazz, making a sort of boot screen. My setup includes (among other things), an IR motion sensor (link) and a display being driven by the U8glib. The IR motion sensor requires a calibration time. Instead of the LCD being blank, I want to do a countdown. But this is unfortunately not in the loop() section, but in the setup() section. Any attempt to do

Code: [Select]

u8g.setFont(u8g_font_fur14);
u8g.drawStr( 10, 35, "HAMMOND");


in that section just gets ignored by the display. Any ideas on how to do this? I really appreciate your help, and here is my full code if you want to take a look:

[EDIT: code in next post because it's too long!]

(I know it's really long, that's because it includes a LOT of other things, but I tried to keep it as neat and labeled as I could!)

I actually can't post my entire code because it's too long!  :smiley-sad-blue:

marco_c

You can attach files. Click on additional options at the bottom of the page.
Arduino libraries http://arduinocode.codeplex.com
Parola for Arduino http://parola.codeplex.com

olikraus

Maybe you can just post the setup() code.

Oliver

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy