Pages: [1]   Go Down
Author Topic: Need just a bit of clarification !  (Read 482 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 26
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

          hello all, I have clearly read way too much and now i just need to ask because im clearly confused, i have altered a sketch but i now want to learn to create them. what program should i be using ?
Logged

Massachusetts, USA
Offline Offline
Tesla Member
***
Karma: 212
Posts: 8967
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

In the Arduino IDE you select File->New to create a new, empty, sketch.  Then you start writing.  A good place to start is to copy the code from File->Examples->01.Basics->BareMinimum:
Code:
void setup() {
  // put your setup code here, to run once:

}

void loop() {
  // put your main code here, to run repeatedly:
 
}
Logged

Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Offline Offline
Newbie
*
Karma: 0
Posts: 26
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks a ton ! im not sure how i ended up geting so confused and i spent more than a day downloading cygwin and other stuff to support it. i've altered a few sketches to change options or features for my aero board but i really didnt think i could just open the ide and go HAM! and really why wouldnt arduino have it's own sketch creator duh !!!! i've wasted 48 hrs...i'll never get back    smiley-cry   thanks again !
Logged

Pages: [1]   Go Up
Jump to: