Pages: [1]   Go Down
Author Topic: Project 08 - Digital Hourglass tilt switch issue  (Read 2943 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The tilt switch included in my kit has really short pins. Due to this, I can't seem to get the switch to stay on the breadboard. Anyone else have this issue or have an idea how I can get around this?

Thanks!
Logged

SE USA
Offline Offline
Faraday Member
**
Karma: 40
Posts: 3783
@ssh0le
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

solder them to longer wires or header pins
Logged


Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

You can use just two of the pins and leave the other two in the gap down the middle of the breadboard. This holds the tilt switch firmly in place, although it will be causing a little stress on the component.

Tilt switch datasheet
Logged

Pages: [1]   Go Up
Jump to: