Pages: [1]   Go Down
Author Topic: Attiny84 wiring, using arduino Duemilanove as ISP  (Read 315 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Is it true that the 10 uF capacitor isn't needed to program an attiny84 from an arduino duemilanove?
Logged

Global Moderator
Dallas
Offline Offline
Shannon Member
*****
Karma: 209
Posts: 13016
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset


A 120 ohm resistor is recommended for boards with an FTDI converter.  Various folks have reported success using either a 120 ohm resistor or an approximately 10 uF capacitor.  The third choice is to cut the auto-reset enable trace.

You will have to do something to disable the auto-reset.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I'm asking this because I've seen different schematics for duemilanove and uno.
Logged

Pages: [1]   Go Up
Jump to: