Pages: [1]   Go Down
Author Topic: Uploading issue[SOLVED]  (Read 431 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

First hi,
10 minutes ago, my arduino worked fine and I have uploaded an sketch.
And now, it says me "avrdude: stk500_getsync(): not in sync: resp=0xfe" and won't upload my sketch...
Does anyone has the solution please? Thanks.

EDIT 1:
Oh, and, it's an Arduino UNO, and I'm programming it on an iMac.
« Last Edit: January 05, 2013, 01:36:23 pm by niss36 » Logged

Left Coast, CA (USA)
Online Online
Brattain Member
*****
Karma: 331
Posts: 16525
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Does the PC see the new USB connection when you plug the board into the PC?

If so next step is to perform a loopback test to see if the serial communications link is functioning.

Lefty
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Does the PC see the new USB connection when you plug the board into the PC?
It does.
If so next step is to perform a loopback test to see if the serial communications link is functioning.

Lefty
Already did it, it passes.

But thanks for the answer  smiley
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I don't know what hapenned to my UNO, but now, it says to me "avrdude: stk500_recv(): programmer is not responding" and not the "avrdude: stk500_getsync(): not in sync: resp=0xfe" that I had before...

EDIT 1:
I've rebooted the Arduino IDE and then it says me "avrdude: stk500_getsync(): not in sync: resp=0x30"...
This is SOO strange!! I hope anyone can help me raising this problem, cause it's my alone Arduino card...
« Last Edit: January 05, 2013, 01:31:43 pm by niss36 » Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I think I'm dreaming: my problem's auto-solved!!! No more error message! I'm so confused...
Logged

Pages: [1]   Go Up
Jump to: