Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: lm35dz  (Read 215 times)
0 Members and 1 Guest are viewing this topic.
mahesh
0
Offline Offline
Newbie
*
Karma: 0
Posts: 1
Arduino rocks
View Profile
« on: September 14, 2009, 04:32:59 am »
 Bigger Bigger Smaller Smaller Reset Reset
hello sir,
   i am using lm35dz for temp. mapping but i can not get mv in o/p. so what is the proper circuit to measure it.  
Logged

AWOL
Global Moderator
UK
Offline Offline
Brattain Member
*****
Karma: 143
Posts: 19380
I don't think you connected the grounds, Dave.
View Profile
« Reply #1 on: September 14, 2009, 04:42:34 am »
 Bigger Bigger Smaller Smaller Reset Reset
With a 5V analogue reference, you should get about two counts (5 / 1024 = 4.88mV / count) per degree on an analogue input pin.
If you need to measure temperature below zero Celsius, you'll need to offset the negative voltages.
« Last Edit: September 14, 2009, 04:45:22 am by AWOL » Logged
Pete, it's a fool looks for logic in the chambers of the human heart.

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: