Go Down

Topic: Fine-tune and save Servo positions in file? (Read 298 times) previous topic - next topic


My biped robot project has 22 standard servos. Programs for robots like RoboPhilo have fine-tuning tab for servos. I'm using Dagu Spider Robot Controller based on Arduino Meta 1280 board. Is it possible for me to create code that lets me fine-tune servos?



Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131