Pages: [1]   Go Down
Author Topic: Arduino Automatic Signal finder and tracker ,used on radio scanner ,,  (Read 214 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Full Member
***
Karma: 3
Posts: 132
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

it works like this ,, there is a signal analog 0-5Volt , and a Arduino checking the analog RSSi signal .
when it detect a signal on example the radio scanner , it wil switch on and sweeps 180 degrees , in the sweep it uses steps from 1 to 180 degree , every step wil be monitored and if the signal in higher then the step before , the eprom wil store this position !
after the sweep it wil go back 2 the position with the highest signal , and wait till the signal drops , and starts again ,, it also checks if its the same signal , and when signal is identical it wil not sweep , it waits !...... LOL

if you like 2 try the code ,, email dexterbot@hotmail.com
« Last Edit: August 08, 2014, 04:39:14 am by Dexterbot » Logged

Offline Offline
Full Member
***
Karma: 3
Posts: 132
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

i added a file code to bigg

* automatedtracker_lcd_rssirecation_meterback.ino (19.01 KB - downloaded 7 times.)
« Last Edit: August 08, 2014, 04:45:14 am by Dexterbot » Logged

Offline Offline
Full Member
***
Karma: 3
Posts: 132
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

or this version  smiley-wink
Logged

Pages: [1]   Go Up
Jump to: