Pages: [1]   Go Down
Author Topic: Q about power sources  (Read 583 times)
0 Members and 1 Guest are viewing this topic.
Kansas
Offline Offline
Newbie
*
Karma: 0
Posts: 2
I AM ON FIRE!!!!!!!!!!!!!!!!!!!.................get a fire extenguisher, please?
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

hi, i am very new to arduino and have little to no experience with this type of hardware

 and was wonderin if i was to connect some motors to my arduino can I construct or buy somethin that would allow me to run power to the motors without running it through the arduino?

  (the electric moters i was planning to use come from a toy bulldozer and use 4 or maybe 6 D -ize batteries and i dont think i should pull that amount of current or power through the arduino circut)

any help would be appreciated
Logged

Offline Offline
Faraday Member
**
Karma: 67
Posts: 2674
The last thing you did is where you should start looking.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Relays and Transistors will isolate your Arduino from your motors.
Logged

The way you have it in your schematic isn't the same as how you have it wired up!

Kansas
Offline Offline
Newbie
*
Karma: 0
Posts: 2
I AM ON FIRE!!!!!!!!!!!!!!!!!!!.................get a fire extenguisher, please?
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

thanks, now to google those things
Logged

Offline Offline
Faraday Member
**
Karma: 67
Posts: 2674
The last thing you did is where you should start looking.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

http://arduino-info.wikispaces.com/RelayIsolation
http://arduino-info.wikispaces.com/DC-Motors
Logged

The way you have it in your schematic isn't the same as how you have it wired up!

Johannesburg. UTC+2
Online Online
Faraday Member
**
Karma: 95
Posts: 4308
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

You might also find this useful: it explains the transistor in words that made sense even to moi.
Logged

Roy from ITCrowd: Have you tried turning it off an on again?
I'm on LinkedIn: http://www.linkedin.com/in/jimbrownza

Phoenix, Arizona USA
Offline Offline
Faraday Member
**
Karma: 40
Posts: 5575
Where's the beer?
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Most DC motor controller boards and shields (like the popular ones based on the L293 and L298) for the Arduino allow you to power the motors via an external power source. Some require the Arduino board to supply the logic supply for the h-bridge; others have an on-board regulator, and can take the power from the motor supply. Some have jumpers to select what you want; some can even power the Arduino (ie, the supply for the motor and driver board also powers the Arduino).

Above all else, you need to know the voltage of your motors, and the worst-case (stall) current needs of them - before you can select -any- controller. If you don't have a multimeter to measure this, that meter should be your -first- purchase.
Logged

I will not respond to Arduino help PM's from random forum users; if you have such a question, start a new topic thread.

Pages: [1]   Go Up
Jump to: